Cutters

Broach cutting using MAGTRON cutters means you can produce large diameter holes efficiently and quickly with less energy, faster penetration and less thrust.

Rather than drilling out the metal with a solid bit, Magtron cutters remove only the periphery of the hole, ejecting a slug at the end of the cut.
Tests show that a solid bit will take 3 minutes, 45 seconds to drill a 32mm hole in 20mm plate. A Magtron cutter can do the same job in 35 seconds!

Cuts clean holes faster
Cuts more holes before resharpening
Cuts on curved surfaces
Cuts overlapping holes
HSS and HSS-Cobalt milling cutters and tungsten carbide tipped cutters are available in a wide range of lengths and diameters with 5 to 18 cutting edges. Cutters can also be made to special requirements.

A full resharpening service is available.
MAGTRON (UDCE Ltd)
Dalweg 1 (Pinnepot II)
3233 KK  Oostvoorne 
The Netherlands 		  

Tel. +31 (0) 181 404563 
Fax +31 (0) 181 404373
info@magtron.com